Unknown Brand

Remote cable for IC-M802 and IC-M803. Length: 1 m.

Unknown Brand

The AA-35 active antenna has been especially tuned to the frequency range of 100kHz to 30MHz and perfectly suitable for the MRD80 as well as every other marine receiver.

Unknown Brand

RF coaxial cable, saltwater-resistant insulation, ideal connection cable for antennas and radio equipment. Outer Ø: 5 mm for cable lengths up to 20 m and transmission power up to 25 W, 50 Ohm, damping ratio 20 dB per 100 m at 160 MHz.

ICOM

The AT-140 automatic antenna tuner from ICOM is suitable for 1.6 to 30 MHz. Ideal for whip antennas, backstays etc. For 100 watts continuous power or 150 watts PEP 45 memorised frequencies for fast tuning Sturdy weather and splash resistant ASA housing Automatically reduces transmitting power during the tuning process and increases again after Tuner through function for better reception Designed especially for the IC-M802 marine transceiver 13.6 volts DC operating voltage - directly through the ICOM transceiver Designed especially for HF-radio on sailing boats and yachts Matching control cable OPC-1147N for the IC-M802 is optionally available Tuning accuracy about 15 seconds - (re-tuning for a memorized frequency approx.1 sec)

ICOM

The AT-141 is an antenna tuner specifically designed for shortwave transceivers. Equipped with a splash-proof housing, the AT-141 is ideal for maritime use and has all the necessary connections for the use of, eg, the backstay as a radio antenna for transmitting and receiving. 100 watts continuous power or 150 watts PEP 45 memory 13.6 V DC power supply Especially for HF marine radio on sailboats and yachts Connection to the device: PL socket Dimensions: 340 x 230 x 80 mm Weight: about 2.5 kg

Unknown Brand

These backstay terminals are designed for attaching to the insulated backstay and provide a watertight connection for the high voltage cable (GTO-15). Supplied with screws.

Unknown Brand

BNC connector, straight. 50 ohms.

Unknown Brand

BNC crimp connector for 6mm RG58 cable, 50 ohms.

Unknown Brand

The 60 mm wide copper strip is the connecting line between SSB ground plate or earthing plate and antenna tuner. The connections between ground and tuner should be kept as short as possible. WD-40 is suitable as corrosion protection for the copper strip. Price per meter.

Unknown Brand

The H040F deck insulator is specially designed for yachts with metal hulls where the tuner is installed below deck. A hole of at least 25 mm should be drilled in the hull for installation. On steel and aluminium ships the bushing must be insulated for HF use. This is made possible with the deck insulator.

GARMIN

The 24x HVS dual frequency GPS antenna from Garmin delivers exceptionally precise, up-to-date position, speed and time data to your plotter via the NMEA0183 output. Receives the signal of several global navigation satellite systems, such as GPS, GLONASS, Galileo and BeiDou. Multi-band GNSS provides precise location accuracy to within 1 metre. The magnetic heading sensor provides accuracy to within 3 degrees (regardless of speed), stabilizing charts and radar overlay. Fully sealed and robust plastic housing is guaranteed to withstand the most extreme maritime weather conditions. 10 Hz update rate with a baud rate of 38400 (can be converted to 4800 baud by installing the "Rate-Change" cable). Important information The Garmin 24xHVS NMEA0183 GPS antenna is factory set at a baud rate of 38,400. If you wish to connect the antenna to devices that only accept GPS data at a baud rate of 4800, the baud rate of the Garmin 24xHVS GPS antenna can be adjusted to 4800 as follows: Connect the short "Rate-Change" cable to the orange "Accessory-ON" wire of the antenna. We recommend soldering the connection and then insulating it with heat shrink tubing. Then connect the cable to the "Accessory" connector or the NMEA0183 data negative/ground of your end device. . Cable configuration 12V+ (incl. 1A fuse) Red 12V- (ground) Black Accessory-ON Orange (if your terminal does not have an "Accessory" connection, the cable should be connected to 12V black). NMEA output + (A) Grey NMEA output - (B) White/Red NMEA input + (A) White NMEA input - (B) White/Orange Pulses per Secon (PPS) Purple Technical data Voltage 8-33 V Dimensions 91.6 x 49.5 mm Weight: 201 g Cable length 6 m Accuracy < 1 m Temperature range -30 to +80° C Material Plastic Waterproof IPX7 Compass-safe distance 150 mm NMEA0183 Yes

Unknown Brand

Better reception for your GPS devices, weather decoders, weather receivers, as well as MF/HF transmitters! This grounding plate is made of porous bronze material to maintain the correct grounding characteristics and to reduce interference. Round version.

Unknown Brand

Better reception for your GPS devices, weather decoders, weather receivers, as well as MF/HF transmitters! This grounding plate is made of porous bronze material to maintain the correct grounding characteristics and to reduce interference. Square version.

Unknown Brand

Better reception for your GPS devices, weather decoders, weather receivers, as well as MF/HF transmitters! This grounding plate is made of porous bronze material to maintain the correct grounding characteristics and to reduce interference. Square version.

Unknown Brand

High-voltage cable (GTO-15) for insulated backstay. The cable is similar to the GTO-15 cable and is best suited for SSB applications. Cable cross section: 6 mm². Dielectric strength up to 1.5 KV, UV-resistant. Suitable for our standoffs and backstay terminals. Price per meter.

Unknown Brand

Remote cable for the IC-718 CIV.

Unknown Brand

Feed various antennas with the AA-EW250 input switch. Suitable for frequency ranges from 30 kHz to 110 MHz. To protect against short circuit, the AA-EW250 has a glass tube fuse in the antenna cable. The input switch is protected against reverse polarity. The maximum applied voltage must not exceed 50 V DC. Technical specifications Max. DC 35V DC Max. electricity 250 mA Impedance about 50 ohms Frequency range 30 kHz to 110 MHz Integr. fuse Yes, 500 mA, delay (5 x 20 mm)

Unknown Brand

The KISS SSB grounding system operates on all frequencies from 2 MHz to 30 MHz with a SWR of 1.2 or less. It consists of a 119 cm long cable attached to the "grounding screw" of your tuner (ATU). Position the remaining 3m hose in the hull of the boat. Keep the KISS SSB system away from other cables and electrical systems as these may interfere with the KISS SSB system. The KISS-SSB is only connected to the tuner and not to the yacht's on-board electrical system.

Unknown Brand

Novel, highly flexible 50 ohm coaxial cable for high performance. Extremely low absorption, bend radius of only 40 mm. Low-loss, stray radiation protected and can even be used in the microwave range.

ICOM

The long range digital radio for every yacht. When used in combination with a Pactor modem, the only crisis-proof means of communication with worldwide coverage. Featuring a distress button, audio replay and GPS, the IC-M803 is packed with functions for even safer voyages. NOTE! For export only! Not for ships flying the German flag. Permitted under Swiss flag according to Bakom regulations. You can find more information in our SSB guide. Features and properties at a glance Digital Signal Processor Integrated GPS receiver NMEA output for external units (NMEA0183 ver. 4.10 format) 150/100/60/20 watt output power Large colour LCD display and intuitive user interface Two minutes instant replay memory With DSC controller ITU Class E RS-232C ports for Pactor modem, PC and other devices Port for AT-140 antenna tuner (available separately) Modular design SSB/AFSK/CW Continuous receiver coverage: 0.5-29.999 MHz 13.8 V DC operating voltage

ICOM

Digital SSB radio with EU approval and long range suitable for all yachts. Featuring a distress button, audio replay and GPS, the IC-M804 is packed with functions for even safer voyages. You can find more information in our SSB guide. Features and properties at a glance Digital Signal Processor Integrated GPS receiver NMEA output for external units (NMEA0183 ver. 4.10 format) 150/100/60/20 watt output power Large colour LCD display and intuitive user interface Two minutes instant replay memory With DSC controller ITU Class E RS-232C ports for Pactor modem, PC and other devices Port for AT-141 antenna tuner (available separately) Modular design SSB/AFSK/CW Continuous receiver coverage: 0.5-29.999 MHz 13.8 V DC operating voltage

ICOM

Digital SSB radio with EU approval and long range suitable for all yachts. Featuring a distress button, audio replay and GPS, the IC-M804 is packed with functions for even safer voyages. You can find more information in our SSB guide. Features and properties at a glance Digital Signal Processor Integrated GPS receiver NMEA output for external units (NMEA0183 ver. 4.10 format) 150/100/60/20 watt output power Large colour LCD display and intuitive user interface Two minutes instant replay memory With DSC controller ITU Class E RS-232C ports for Pactor modem, PC and other devices Port for AT-141 antenna tuner (available separately) Modular design SSB/AFSK/CW Continuous receiver coverage: 0.5-29.999 MHz 24 V DC operating voltage

ICOM

10 m control cable for the AT-140 ICOM antenna tuner in connection with the IC-M802 shortwave transceiver.

ICOM

Connection cable for the IC-GM800 and IC-718 in connection with the AT-141 tuner.

Unknown Brand

Coaxial connector for lower-deck use.

Unknown Brand

PL connector for 10 mm RG213 cable.

Unknown Brand

PL connector for 6 mm RG58U cable.

Unknown Brand

Angle connector: PL female to PL male.

Unknown Brand

RG213 coaxial cable, saltwater-resistant insulation, ideal connection cable for antennas and radio equipment. Outer Ø: 10 mm for cable lengths up to 50 m and transmitting power up to 200 W, attenuation 8 dB at 100 m and 160 MHz.

Unknown Brand

Audio cable to connect Pactor modem to IC-M802 or IC-M803. Length: 1 m.